I am now making the final preparations needed to eventually install the sole (what most people would call the deck). Before I do this, I will need to install two 40 gallon fuel tanks and plumb them. I will also need to finish the bilge and figure out how I'm going to drain the cockpit. What I did here is simply seal the G frame.	I didn't show this on the previous page, but I have completely finished foaming, even back here under the motorwell.	The motorwell sole has been cut and I cut holes for chase tubes to come up through.
	The chase tubes were installed using only 45 degree elbows and I can easily run fishtape through them.

  Copyright© 2004 - 2007 by Michael D'Amour. All rights reserved.